Vanderblog

A forum for flatbed cylinder proof presses
18 Feb

Replacement feed board edge for Universal III

I am preparing to have a few of these aluminum feed board edges made up by a machinist. Does anybody else need one? So far I think its Bryce Knudson and myself. And Fritz- did you need one for that press out back?


The ruled guide next to the slot in which the side guide travels appears to have been chemically etched into the part as does the center line marker. I can recreate these digitally to burn a negative for the etching process, but does NA Graphics by any chance still have a printout or a transparency in the files for this? It will definitely make my life easier…


Daniel Morris

The Arm Letterpress

Brooklyn, NY


Uni III Feed Board Edge Ruler Guide

Leave a Reply

To contain spam, your initial comment will be held in the moderation queue. Once approved, subsequent comments will be published immediately.

Please revisit your user profile by selecting your logged in name below. Fill-in your real name and website address so that members will give greater credence to your posts and comments.

You must be logged in to post a comment.

Vanderblog is powered by Wordpress | GPS Theme by GPS Gazette, modified by Paul Moxon