Hi, folks. I am writing about a damaged Uni I that I have been working on intermittently over the past 10 months. When the press was shipped to me, it was struck and dragged along the right-hand side of the carrriage. Obviously I’ve learned my lesson where crating is concerned but I cannot for the life of me get the cylinder balanced. Recently I had faked, so to speak, an even impresssion by dramatically altering the bearing settings but the press felt awful to print on and I imagine I was creating more problems for my self down the road. At present, I have removed all bearings, eccentrics, etc. and the cylinder is tilted high on the right-hand side and low on the left-hand side. My frame of reference is the smooth inner rail running closest to the press bed. In trip, the left-hand side is making contact with this rail. On my other presses, the proper distance seems to be roughly 1/8″ distance from cylinder to rail when in trip and drops down to make contact when in print. Any feedback would be greatly appreciated. Thank you.
all best,
Patrick Masterson