Comments on: Vandercook #3 Oscillating roller http://vandercookpress.info/vanderblog/2008/04/vandercook-3-oscillating-roller/?utm_source=rss&utm_medium=rss&utm_campaign=vandercook-3-oscillating-roller A forum for all brands of flatbed cylinder proof presses Wed, 23 May 2012 01:56:00 +0000 hourly 1 By: The Arm NYC http://vandercookpress.info/vanderblog/2008/04/vandercook-3-oscillating-roller/comment-page-1/#comment-1884 The Arm NYC Fri, 04 Apr 2008 22:15:06 +0000 http://vandercookpress.info/vanderblog/2008/04/03/vandercook-3-oscillating-roller/#comment-1884 Aimee has a set of the three roller cores needed for this press, but needs an oscillating roller assembly (#3 or #4 is fine), form roller gears, and the hand crank that mounts on the rubber drive roller. She could also use a taper for the cylinder crank handle and a lockup bar or dead bar. Daniel Morris The Arm Letterpress Brooklyn, NY Aimee has a set of the three roller cores needed for this press, but needs an oscillating roller assembly (#3 or #4 is fine), form roller gears, and the hand crank that mounts on the rubber drive roller. She could also use a taper for the cylinder crank handle and a lockup bar or dead bar.

Daniel Morris
The Arm Letterpress
Brooklyn, NY

]]>