I recently had my Universal IV sort of sputtering during the run. On occasion the carriage would stop for no reason right in the middle of its journey down the bed. Standing on the drive-side of the press trying to figure out the cause, I happened to kicked the cable which powers the motor, and the press took off again. I called an electrician, and he confirmed that there were breaks in the wires within the cables. We would run the press while he shook the cable back and forth, which seemed to prove that it was a problem with the electricity going to the motor. He worked on it for a little while, replacing and patching, and then the press ran beautifully again. I think it cost me $160.

Michael Russem

I have seen the power Uni III get a bit jumpy if the variac starts to get tired. If you adjust the speed a bit slower or faster it will suddenly run better.

I’m no electrician, but I’ve had temporary success in alleviating the symptoms by cleaning the contacts on the back of it with electrical contact cleaner.

Daniel Morris
The Arm Letterpress
Brooklyn, NY

Terry,
Re: Chain issue.

I have a Universal 2, which is much like the Uni 3 and have had a similar problem with slack in the chain. Do not shorten chain (huge headache)! I found two things that may help:

1-You may have a tight link in the chain, so it sticks/skips in one particular spot. If so, get some slack on the chain and bend it against the way it runs to loosen it (and oil it).

2-Move the motor back. If it is the same as mine the motor sits on a bracket which is bolted to the frame. If you can slide back a bit, do so, if not remove the whole bracket and slip washers on each bolt before re-attaching.
Good luck
Adrian

Terry,
Greetings from a former Memphian! Haven’t thought about Prince Mongo in years, and very few people in Chicago seem to know who Jerry “the King” Lawler is. To your query regarding the Vandy 4: I think the small parts you were referring to are nyliners. They are referenced in the article “Common Vandercook Operator Errors” by Paul Moxon which is posted on this site. I didn’t have to replace them, so I don’t have a supplier, but maybe this information will help you.
Patti Montgomery

The rider rollers on the ink drum assembly have wood bearings, and I stock them. As for the jumpy motor, I can’t really say. Clutch maybe–the clutch plates do wear and those are still made but expensive, and again, I have a set in stock. Perhaps the clutch spring is bad or broken, then there’s the worm drive inside the gear transfer case–one steel worm and a bronze one. The bronze worm can eventually strip out causing something like what you describe. Again, not a cheap part but I have 2 of the bronze worms in stock and I think they may be the ones for the Univ III clutch. If a motor problem, it may require rewinding, perhaps new bearings but in any case, never throw away a Vandercook motor–there generally are no replacements and they have to be rebuilt.