Universal III Gripper Assembly Cleaning

Hi–I’ve taken apart the gripper assembly to give it a good cleaning. In the past I’ve used Simple Green to soak everything and loosen the grime and then used a toothbrush to get in all the nooks and crannies, etc. Graphite to lubricate and then I put it all together again. BUT this time, I’m out of Simple Green. Can I just use Dawn and water? Or is water bad b/c of rust? Even if I let everything dry completely? Thanks…..

Universal III Gripper Assembly Cleaning

2 thoughts on “Universal III Gripper Assembly Cleaning

  • April 8, 2018 at 10:59 pm
    Permalink

    The grippers were really sticky, the last time I cleaned them was more than a few years ago. Good to know about the Simple Green–I’ll definitely follow up with WD-40, thanks!

  • April 8, 2018 at 10:04 pm
    Permalink

    I only use a degreaser for real grimy parts. You should note that Simple Green is water-based and can cause rust. I normally follow-up with WD-40 which displaces water. If you have previousy cleaned the grippers I can’t image that they’re too dirty. I would just use with WD-40 on its own.

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.