Hi All, I read the posts in the Vanderblog archives about SP15 ink drums wobbling because of a broken plastic gear or shorn off screws. Is it the same fix or different on a Uni 1 AB? On our Uni 1 AB, while printing we noticed that the lower steel ink drum was not inking [...]

Hi All, I just received two newly recovered rubber rollers for a #4, done by Rotadyne. I measured the rollers and one is bigger than the other in diameter by 1/32″. One roller is 2 1/2″ and one is 2 1/2 plus 1/32. I asked the roller company to make them 2.515″ in diameter. Should [...]

What do you think is the narrowest space that a Uni I could fit through without taking the press apart? I am looking for a house and this question came up. We like one house with a walkout basement but the doorway is only 31″ wide. Thanks for your input!

Hi all, I have been talking to Fritz and trying to figure out why the Universal 1 hand press I own always wants to flip back to Print and not stay on Trip. I can hold the Trip/Print handle on Trip and it will stay in Trip mode, but as soon as I let go [...]

I have a question about a Universal I hand press. The problem first became noticeable after setting the rollers to the correct height and printing for a while. The back inking roller gear will sometimes jump off the track when in print mode and make a terrible sound. We were able to replicate the problem [...]