Best way to remove rust?

5 thoughts on “Best way to remove rust?

  • August 10, 2009 at 1:36 pm
    Permalink

    Gerald,

    I’ll give it a try.

    What website do you order from or do you purchase the Rust Bomb local?

    I checked in my area and they don’t sell it retail.

    Casey

  • July 31, 2009 at 2:19 am
    Permalink

    Laurie

    Thanks for your reply. One thing that I should add is that after you remove the Rust Bomb, apply their rust inhibitor, Rust Bandit. When that dries, rub on the Lemon Pledge. Orison sells both a water-based rust inhibitor, Rust Bandit, and an oil-based rust inhibitor, CP-90. The latter is a great substitute for WD-40 as it not only displaces water, it prevents rust from occurring, AND, it lubricates. Unlike WD-40, this stuff literally sticks around.

    I have a carrier sheet for my photopolymer platemaker and it started getting rusty, so I used the Rust Bomb, followed by Rust Bandit (yes, even though it would be submerged, I used the water-based inhibitor), followed by Lemon Pledge as a seal. Nine months now, no rust.

    Orison makes a great line of products.

    Gerald

  • July 30, 2009 at 12:45 am
    Permalink

    Laurie

    Apologies to Casey but Rust Bomb is THE way to go. Followed by a spray of Lemon Pledge. Best for all press beds, paper cutters, et al. No abrasion, no staining. Non hazardous, sewerable. Same folks who supply Evapo-Rust. Fantasic product line, and no bullshit.

    Gerald
    http://BielerPress.blogspot.com

  • July 29, 2009 at 4:36 pm
    Permalink

    I use Loctite Naval Jelly. Then put a a good coat of oil for complete coverage, then whip it down real good so there is only a thin layer.

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.