Universal III P just stopped

First, I’m looking for someone in the general vicinity of Delaware that can troubleshoot and possibly repair an automatic Vandercook Universal III. Know anyone? If not, is there some kind of electrician I might try contacting. Obviously, I need more than someone to hook up a 3-phase here.

We were running our III the other day and as the cylinder ‘approached’ the end of its trip away from the feedboard, it simply stopped.

We checked fuses which were blown. We replaced them, but they immediately blow.

If you set it to Manual, the forward / reverse switch causes the relays to activate, but nothing moves.

Thoughts?

Universal III P just stopped

4 thoughts on “Universal III P just stopped

  • February 1, 2011 at 7:18 am
    Permalink

    We called Perry. Got someone from his place down to Delaware from Staten Island.

    Turned out to be the motor.

    The bushings were getting very worn and one of them turned sideways in the motor. We’re getting that fixed. Pretty expensive overall, but couldn’t work without it.

    Thanks to everyone who contributed ideas. Fritz had it right in his list of possibilities.

  • December 12, 2010 at 8:15 pm
    Permalink

    Three phase? What’s the serial number of this press? The motors are dc, normally single phase ac and there is a rectifier that converts the ac for the motor. Sounds like a short in the motor, wire harness that connects with the motor, or a broken wire somewhere. Perry is mainly Northern New Jersey and New York City, but give him a call (201-435-5409).

    Fritz

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.