SP20, Roller Rack

Hi,

I have been helping a friend with cleaning and readjusting his SP20. Now that we’re almost done the moveable end of the roller rack seems to be sticking a bit too far up. The press hasn’t been used for probably something like 20 years… So hard to tell why that is. Anyway, the spring probably has to be shortened or replaced. Can anybody tell me what the perfect angle is for this? How much does it need to stick up?

Thank you very much. Best wishes from Switzerland.

Dafi

 

IMG_7485

SP20, Roller Rack

10 thoughts on “SP20, Roller Rack

  • August 2, 2016 at 8:29 pm
    Permalink

    Thank You, Paul! I learned today something new about my press.

  • August 2, 2016 at 8:16 pm
    Permalink

    Thank You, Paul!

  • August 1, 2016 at 10:37 pm
    Permalink

    Thank You, Paul!
    Is it possible to get a picture of the Roller Rack Spring? Is it a conical spring?
    Rodolfo

  • July 29, 2016 at 8:53 pm
    Permalink

    Rodolfo: The starting tooth with its pointed teeth helps the spinning form roller gear transition onto the form roller rack. When the form roller gear meshes with the teeth on the roller rack the rubber roller will roll and not slide over the printing form.

  • July 29, 2016 at 8:17 pm
    Permalink

    Hi,
    I’m starting to use a recently restored SP 25 in Guadalajara, Mexico. The roller rack of my press has no spring. Please, could you explain me how does the roller rack work? What’s its function?
    Thanks.

  • July 21, 2016 at 2:12 am
    Permalink

    Thank you Fritz, the case is clear. See the attached Photo. I’ll send you an email.

  • July 21, 2016 at 1:52 am
    Permalink

    The starting tooth(BS-429) is in stock as well as the spring (BRS-1). Eric is correct about how the starting tooth works, and I can also furnish the pin if needed.

  • July 21, 2016 at 12:49 am
    Permalink

    Thank you Eric, I sent an email to Fritz Klinke to ask him about it. Best wishes. Dafi

  • July 20, 2016 at 7:55 pm
    Permalink

    If I remember correctly, the starting tooth there pivots on a pin, and on the end opposite the teeth, there is a spur or leg that holds it at the proper rest position against spring pressure. If the spur breaks, then the spring will push the starting tooth higher. Time to replace the starting tooth. I’ve gotten this from NA in the past, hope they are in stock now.

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.