Looking for ball bearings for Vandercook “0” – copy

I have tried to find a similar ball bearing on the open market. The closest size I can find fits all measurements except that the screw that goes through the side of the press (held by a nut on the outside of the press) is 2mm bigger. I would need to drill a bigger hole into the side of the press. Should I do this or keep looking for Vandercook “0” bearings? I need to get the press back into use for public projects.

Looking for ball bearings for Vandercook “0” – copy
Tagged on:

2 thoughts on “Looking for ball bearings for Vandercook “0” – copy

  • December 18, 2018 at 9:48 pm
    Permalink

    Okay. I will check this option out. Sounds good. I really appreciate your advice and I will report back with the results.

    Cindy Marsh

  • December 18, 2018 at 9:36 pm
    Permalink

    Take the The new bearing to a machine shop and see if they can correct or replace the screw. Bring one of the originals too for reference.

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.