SP15 form roller (the one on the right) is moving, getting chewed up a little

One thought on “SP15 form roller (the one on the right) is moving, getting chewed up a little

  • April 14, 2021 at 5:13 pm
    Permalink

    I don’t think a video is necessary. I believe the roller core end screws are not the issue. The cores are moving laterally because of a loose or missing shaft collar.
    The shaft collar should be set approximately 0.010″ from the Nyliner on the bearing block. NA Graphics should have them in stock, but I’ve included the spec to find it locally.

    Additionally, the rubber on the core may have been built slightly too far to the right. A band saw or ant serrated blade can remove the excess rubber.

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.