Uni III Blowing Fuses
Working on some electrical gremlins on a Uni III that is blowing its 5amp fuses (larger ones). When in manual mode, the carriage will go to the end of the bed with no problem but will not return and it
A resource for all brands of flatbed cylinder proof presses
Working on some electrical gremlins on a Uni III that is blowing its 5amp fuses (larger ones). When in manual mode, the carriage will go to the end of the bed with no problem but will not return and it
Recently acquired a tape tower for my Uni III but didn’t realize my press doesn’t have the little cylindrical gripper bar extensions that thew tape tower bar clicks into. Anyone happen to have a spare set (I know, needle in
Looking for advice on an issue that just came up on my Universal III. In my infinite wisdom I decided to swap out the beat up faceplate on the controls with a replacement that I had. While disconnecting the on/off
Over the past month or so, the carriage on our Uni III has developed some hesitation from when you hit the green cycle button and when it actually begins moving down the bed. This morning it finally just stopped cycling, or
Anyone have experience using water based inks on a vandercook? I’ve used oil based for my prints for over 20 years now but am curious about water based mainly to speed up my dry times between colors. Ive ordered some
Ive had my Universal III for almost a year now and have been running some large editions on it. 99.9% of the time she runs perfectly, but occasionally upon returning to the feed table the carriage will slam home with
A new gremlin has reared its head with my Universal 3, I’m having trouble with the cycle start button. Sometimes when the button is pushed nothing happens, if I hold it down it seems to eventually start the cycle and
Anyone know the specs or someone familiar with recoating the rubber roller that is part of the ink fountain on a Uni III? My roller is flared at both ends and the rubber is very hard from age. Thanks
I need to remove the handle from my Universal I to fit the press through a doorway. I’ve searched and saw posts about removing the set screw and tapping out the taper pin. The set screw came out with minimal
Im in the process of refurbishing a Uni3 that has a lot of options that are not existent on the Uni1 thats been my workhorse for over a decade. The one that has me the most perplexed right now is the
Recent Comments