Hello! I recently moved into a new studio and have been having problems with sticky grippers, which isn’t new to me so I didn’t think it had anything to do with the move. Today as I was printing, the pedal
I’m having some trouble printing the front side of a 4bar envelope for wedding invitation reply cards. Even with all the makeready, I still end up with a little impression going through on the backside of the envelope. It’s not
I just got brand new rollers and cores. The weird thing is that when I check my roller height, it’s not even throughout. The ends are the same but the middle of the roller has a thinner stripe when I
The pedal on the press is sticking, I figured the grippers needed to be cleaned so I took that assembly apart and cleaned it, and the pedal is still sticking. Not sure what to do!! In another unrelated note (or
Hi–I’ve taken apart the gripper assembly to give it a good cleaning. In the past I’ve used Simple Green to soak everything and loosen the grime and then used a toothbrush to get in all the nooks and crannies, etc.
I’ve had this issue before and I can’t remember how I fixed it. When I started printing today, there is this noise that is coming from (I believe) from the rear form roller gear not being in the correct position
I want to be able to print multiple colors at once without the rollers moving so much back and forth to muddle the colors together. I know there’s a way to do this by taking something out….the crescent I think?
I’m pretty sure i know the answer to this but……. I have this very beautiful paper that I want to print on and it has a deckle edge. Are there any tips or tricks to get it to print straight?
I have taken a break from printing (it’s been 4 years) and now I’m ready to get back into it. I took pretty copious notes, but for this issue, I can’t remember how to adjust or what the problem is
I am having problems getting the correct inking coverage as well as impression for what I’m trying to print. I apologize if you’ve read about this on the letpress listserv or briarpress….I suppose I should’ve posted here all along. I