Inking issues on SP15
We’re completing the rebuild of an SP15 that was begun by someone else (who is now deceased, so we can’t ask them questions) and we are running into some challenges with the inking system. We were trying to set the
A resource for all brands of flatbed cylinder proof presses
We’re completing the rebuild of an SP15 that was begun by someone else (who is now deceased, so we can’t ask them questions) and we are running into some challenges with the inking system. We were trying to set the
Anyone have experience using water based inks on a vandercook? I’ve used oil based for my prints for over 20 years now but am curious about water based mainly to speed up my dry times between colors. Ive ordered some
I recently attempted to print a very light color of borders that extended from the top of the bed about 10 inches. The ink was mostly composed of white and revealed things about the press that are perplexing. I have
Recently when inking the rollers on my Vandercook SP20 I have encountered the following problems. 1) When I apply ink across the distributor roller and let it down on the form rollers the ink does not spread evenly and there
I have old cans of VanSon Holiday gold paste and a can of gold paste from Cal/Ink. How do you print with these? Do you mix them with varnish or transparent base? Thanks.
Hey Everybody, It seemed like this was going to be a workable problem, but now in actuality it has taken a turn for the worse. Today we printed a navy ink with no problem, then washed up and put PMS
Well, now we have had a little practice with replacing a wooden bushing on a Uni 1 inking drum. I last posted on October 2011 when a bushing had gone on our Universal 1. We just had the wooden bushing
Hi everyone, I recently acquired a Universal 1 and have a couple questions related to maintenance. I have been keeping the rollers raised by raising the lever for that purpose when the press is not in use, but wasn’t sure
Hello All, I’m having a grand old time trying to set the bearings on my Challenge 15mp and it’s been over two weeks of adjusting, proofing and re-adjusting. The main issue I’m finding is that my carriage shifts once the
Hi all, So, the small spring on the far side of the bottom cylinder of my SP-20 broke the other day (the one next to the chain). I replaced it, but I’m still having the same issue of the cylinder
I was operating my Vandercook 320 and all of the sudden, the metal rollers began rattling out of control either while in print or trip mode. The rollers are shaking about so much that they’ve even been tossed off of
I am frustrated with my print quality on my SP15. I am using photopolymer plates to print personalized note cards with small type. The type is very uncrisp. It looks like the ink is pooling on the edges and bleeding
Recent Comments