Universal I stopping when in print, but not in trip
Hi All, I just pulled an old Universal I out from the corner to see what issues there may be. When in Trip the carriage rolls all the way down the bed fine. When I put it in Print, the
No. 4 Trip/Print lever
I’m hoping this is a simple question. What part of the trip/print lever on the No. 4 maintains the lever arm in trip? When I depress my lever into trip and the arm moves upward, but it doesn’t stay engaged
Reprex No 1, endguides and trip
I recently spent a day at Hazel & Violet in Phoenix but left there with two unfinished tasks: This press is missing its end guides. The channel for the end guides are ⅝” wide × 1 13⁄16” high × ½
No. 4 Print/Trip Assembly
I just started working with a friend’s No. 4 press. It prints great and seems like a really solid machine. The machinery used to lower the impression cylinder from trip to print during the print stroke then back up to
Vandercook No. 4 Trip Lever
All of a sudden, the trip lever on our Vandercook 4 will not stay engaged. I didn’t hear anything break, and I can’t see the mechanisms well enough to determine if a spring snapped. Unfortunately, we don’t have a diagram
Universal I Trip Mode
Hello again, I think I’ve narrowed my trip problem down to a lever on the back of the press that isn’t fully engaging. When in trip mode, this lever is coming only halfway up to it’s destination. I figured a
SP-15 Cylinder Carriage Bearings Issues
I undertook the arduous task of adjusting the 6 cylinder carriage bearings on my SP15, after still experiencing uneven inking and impression with newly recovered rollers. Thanks especially to Gerald’s comprehensive “Adjusting Cylinder Carriage Bearings” article, without which I never
SP-15 Trip/Print blocked
We’ve been working on cleaning up our SP-15 in the new UAFS Letterpress Shop. I took the motor cover off to clean a large pile of old ink next to the drum roller. After putting everything back in place, now
No. 4 Trip Issue
Our Vandercook No. 4 does not stay in trip. When printing, the operator has to hold down the trip to keep it in place. In comparing it to our other No. 4, the trip mechanism is still in place, but
No. 3 carriage ‘bounce’
I recently acquired a Vandercook No. 3. There is still a tremendous amount of cleaning to do, but I have it to a point where at least all the oil holes are un-clogged and the parts that are supposed to
Universal 1 hand trip issue
Hi all, I have been talking to Fritz and trying to figure out why the Universal 1 hand press I own always wants to flip back to Print and not stay on Trip. I can hold the Trip/Print handle on
SP 15 Carriage Side Panel removal
Hello all, I recently purchased an SP 15 and am finally getting around to cleaning/restoring it to printing condition. In the process I came across what appears to be a broken trip spring. Since the gears and trip mechanisms were
Recent Comments