Wash-up unit

Auto washup setup for Universal 1

Daniel Mellis May 27, 2014May 28, 2014 Universal series, Wash-up unit 3 Comments

I’m setting up the wash-up tray for my school’s Universal 1. I’m not sure of exactly where to place two rails that form the fixed support for the tray, and I’m also not sure if the moveable support for the

SP-20 Wash-up Blade

maysorum March 6, 2014March 6, 2014 SP series, Wash-up unit 8 Comments

Hello – Has anyone found a replacement source for wash-up blades? Any leads or even blade specs would be greatly appreciated!

Seeking Washup tray for universal-II OR measurements/plans to build

Mark Herschede January 5, 2014January 5, 2014 Universal series, Wash-up unit No Comments

Hello- looking for a wash-up tray for my universal II. Would pay good money if you have one; comparably, compensation could be arranged/negotiated even if you have one and do not wish to sell it, perhaps you could take detailed

Vandercook Universal III Electrical Issues?

Nina Bell July 8, 2011July 8, 2011 Power Carriage, Universal series, Wash-up unit 2 Comments

Hi all, Someone at Briar Press suggested that I post here since you are the Vandercook experts! As a new Vandercook Universal III owner, I’ve got a couple of issues going on that I’m hoping some of you can help

Wash up unit

Dafi November 9, 2010 F.A.G., Inking System, Wash-up unit 3 Comments

Hey, I got a general question about the use of the washup unit. I just got an unused orignal nylonblade for the washup unit of my “FAG Control 405”. Until now I didn’t use the washup unit, since the old

Universal III washup unit

David Glover November 18, 2007November 18, 2007 Universal series, Wash-up unit 11 Comments

I’ve been told by a lot of people that the Universal III washup unit is useless. But, I want to make mine work. The problem I have is that the scraper blade will run into the automatic inking cylinder and