Grendl Löfkvist

Inking issues on SP15

We’re completing the rebuild of an SP15 that was begun by someone else (who is now deceased, so we can’t ask them questions) and we are running into some challenges with the inking system. We were trying to set the rollers to the lightest stripe possible for photopolymer printing, which we did with the press …

Inking issues on SP15 Read More »

SP15 Ink Drum Adjustment

Setting stripe ink drum to form on SP-15. How thick a stripe? And, any easy way to adjust (besides raising and lowering the drum/motor cradle (?) stop foot? It’s not an easy adjustment… loosening two bolts while pressing down on drum, micro-adjusting, then tightening (only to see I went too far). Better solution?