As a result of a plumbing mishap a few weeks ago I have had to clean and re-lubricate the gripper bar on my Universal III AB. In the processes of doing this I’ve run into a few questions and potential problems, and I want to get clarification if I can before I do anything incorrectly. […]
MoreAuthor: Jeffrey Lay
Universal III Cylinder Rack – damaged screws / rocking
Hello everyone! Looking for some advice on how to proceed, I don’t want to do anything irresponsible here. I had a recent plumbing mishap above my in-home studio which deposited some light debris onto my Uni III AB. After a particularly thorough and careful cleaning of the press, I noticed some problems. In the process […]
MoreLooking for advice. Part 2: Uni III(ab) paper guide crooked(?)
Hello again! So in the process of getting back in the saddle I also noticed another quirk on my Universal III. I’m not sure if it is a problem per se or if the problem is just me… I noticed that all the prints I have been pulling are consistently cocked out of square a […]
MoreLooking for advice. Part 1: Uni III(ab) form roller tilted
I have recently begun to produce work on my Uni III after a long hiatus, and have run into a couple of vexing issues. Firstly, I realized that the rear form roller was laying down ink only on the side opposite from operator. The roller will not adjust low enough on the operator side (the […]
MoreUniversal III Janette Motor – Lubrication
PHOTO CORRECTED BY MODERATOR. I received my new-to-me Universal III AB this week and have been dutifully cleaning and oiling this magnificent press. In the process I’ve run into a snag owing to my lack of experience with small motors. I cannot figure out where to oil the motor. Hoping someone may have experience with […]
MoreUniversal III (hand) carriage question
Greetings! I have recently made a purchase of a Universal III press and am currently ironing out shipping. The sole wrinkle in getting this press into my studio is that the carriage is too wide for a few interior doors (this is a old home) by three inches. My two options are to keep said […]
More