Cylinder

Aligning Vandercook No. 4 Cylinder Carriage

Hello Vanderblog, I am working on getting my recently acquired No. 4 (Serial No. 14509) working and have a couple of questions about how to go about removing the cylinder carriage and getting the gears to line up correctly again. To give you a little backstory, as far as I know, this press belonged to …

Aligning Vandercook No. 4 Cylinder Carriage Read More »

Reel rod

Is it possible to remove the reel rod on the No. 4 ? I want to get in there real good with a brush, it’s nasty in there. I found two hex nuts and tried both ways but couldn’t get it out. I also unscrewed the ratchet but I can’t see how the reel rod …

Reel rod Read More »