Subscribe
Notify of
4 Comments
Newest
Oldest Most Voted
Inline Feedbacks
View all comments
Paul Moxon, Moderator
Admin
7 years ago

Matt: yes, that’s how Challenge meant for Nyliners to be installed on the M series. The retainer clips (snap rings) are an inexpensive hardware store item. However, it’s easier to install them with snap ring pliers.

You should also have a shaft collar on the front form roller that minimizes lateral play. Position it approximately 0.010″ from the Nyliner/bearing block.

mattkelsey
mattkelsey
7 years ago

I have a somewhat
related question.Is it okay to install the Nyliners so they are on the inside of the roller blocks? That way you don’t need the retaining clips on the outside, some of which I have lost. It seems to work, not sure if I am causing other problems. This is for a Challenge MP15, which is mostly a clone of the Vandercook SP15.

Matt

The Arm
7 years ago

These are also in stock at NA Graphics.

Paul Moxon, Moderator
Admin
7 years ago

I have a pair for you. But you could make them out of sheet metal. Yo could also use one nyliner on each shaft with a 0.6875″ long.

Copyright © 2024 vandercookpress.infoTheme by SiteOrigin
Scroll to top
4
0
Would love your thoughts, please comment.x
()
x