Subscribe
Notify of
1 Comment
Newest
Oldest Most Voted
Inline Feedbacks
View all comments
Paul Moxon, Moderator
2 years ago

I don’t think a video is necessary. I believe the roller core end screws are not the issue. The cores are moving laterally because of a loose or missing shaft collar.
The shaft collar should be set approximately 0.010″ from the Nyliner on the bearing block. NA Graphics should have them in stock, but I’ve included the spec to find it locally.

Additionally, the rubber on the core may have been built slightly too far to the right. A band saw or ant serrated blade can remove the excess rubber.

Copyright © 2024 vandercookpress.infoTheme by SiteOrigin
Scroll to top
1
0
Would love your thoughts, please comment.x
()
x