Hi all,
So, the small spring on the far side of the bottom cylinder of my SP-20 broke the other day (the one next to the chain). I replaced it, but I’m still having the same issue of the cylinder being too low on that side. It’s not inking at all, and the chain is hitting the inside of the press as it turns. I’m not sure what adjustment to make in order to remedy this.
Any help is greatly appreciated.
Samantha Urbanick
Hand Deliver Press
Asheville, NC
Samantha@handdeliverpress.com
I replied to this question via text to Ele. There’s an adjusting screw behind the drum on either side. Place a spirit level on press bed and then the drum.