IMG_853IMG_8534 The body of my #4 is damaged. The corner opposite the operator at the far end of the press bed is not supported. You can see that the bottom of the frame is not level as well. Bringing the carriage to the end of the press causes it to rock back and forth. I […]
MoreAuthor: Allison_Igloo
Universal I carriage “skipping”
Well, after 25 years of printing on Vandercooks, I encountered a new problem today. There is a 1/2″ strip across the whole sheet that is not printing with the correct impression. It is illogical, but it seems that the carriage raises up just for that line of type and then goes back down. The press is […]
MoreUniversal Problem
I am having a problem with a roller on my Universal. The roller closest to the feed board is binding and can’t be removed. The offending area is opposite the press operator. We can not move the carriage and the roller is not spinning. We believe that a screw has worked loose and is not […]
MoreNew metal wear creating a burr
Hi – I am noticing new wear on my Vandy #4. A burr is being created at the top and bottom of the metal shown in the picture. You can see the shiny new metal that has been exposed. This is the operator side of the press. I don’t see anything on the other side. […]
More