I just received a request for the specs for the cores for a No 1 Reprex. this is the same one posted on Briar press. I will make a drawing and share a pdf on this site. 
 
I need:
– overall core length
– diameter and length at ends
– other diameter and length on the core
– position end to end and length of rubber on the core
– diameter and number of teeth on gear––– ideally a scan of a rubbing or print of the gear
– note any flat spots for set screws or woodruff key  
 

Warning: Attempt to read property "content" on int in /home/p4ulm0x0n/public_html/vandercookpress.info/wp-content/plugins/nextgen-gallery/products/photocrati_nextgen/modules/third_party_compat/module.third_party_compat.php on line 490

Warning: Attempt to read property "content" on int in /home/p4ulm0x0n/public_html/vandercookpress.info/wp-content/plugins/nextgen-gallery/products/photocrati_nextgen/modules/third_party_compat/module.third_party_compat.php on line 490

3 thoughts on “Reprex No 1 Rollers Specs”

  1. Fantastic! The person requesting this info hasn’t used this press yet, it belongs to a school. I Marked out the info about the cores because she located them. However, if you’ve made drawings I’d love to post them. I especially like to have the gear specs and know if there’s any machining on the journal ends of the cores.

  2. Paul I can send you all of the above information tonight. I don’t have the information in front of me, but I machined new cores and gears and had them covered for my Reprex a few months back.

    Lee

Leave a Comment