I am working with an sp 15 that doesn’t stop at the end of its run, also the grippers will not release. Are these two issues related? Am I missing a part? Thank you. Sally Faulkner
MoreCategory: Grippers
Vandercook #4 gripper adjustment
We are going through the process of getting our Vandrcook #4 back into use. One issue we have almost solved is the grippers did not move either at the feed table end or the tail end of the bed. In addition, the foot pedal would not move the grippers at the feed table end. We […]
MoreNo.4 foot activated gripper not working
We have a Vandercook 4 and the foot activated lever that opens the gripper stopped working. The lever is attached to the chain that then goes up through the cabinet and across under the bed to a push rod that pushes out the lever that works the grippers. The problem is in the connection between […]
MoreVandercook No. 3 Gripper Lever
Finally got around to fabricating a hand lever for the No. 3 grippers. Works like a charm and no longer will I be rolling the cylinder back and forth in an attempt to properly grip/register sheets. I can share the specs with anyone interested… just let me know. Brad.
MoreCleaning up a #3
Hello Vanderfolks. I am in the process of finally getting my old #3 up and running again. A lot of dust, dirt, a little rust and the paper clasp pins don’t open. Looks like I have mostly cleaning and lubricating to do. My question is really simple. For those of you who have been through […]
MoreGraphite powder suitable for gripper posts
Would the type of graphite sold for bicycle chains be suitable for lubricating SP-15 gripper posts? But I was hoping to find it in a dispensable container, not pressurized in a can, to avoid a mess. Where’s a good spot to find it in small quantities? Thank you.
MoreSP15 grippers and trip lever issue
Hello. I have a lovely little SP15 and this is my first mechanical issue I’ve experienced thus far. I hope someone can help me solve it… Yesterday, my grippers stopped working. In looking at the manual and the press, I see the gripper cams are not lined up with the gripper screws. I am not […]
MoreStuck SP-20 Grippers
I’m rebuilding the gripper assembly on a very dirty SP-20. The pins are jammed in the holes due to the previous owner’s habit of just shooting WD-40 around the pins instead of lubricating them with graphite powder or grease. I’ve tried pulling them out, but they seem glued in there. I don’t think bent pins […]
Morefrozen bearings & paper gripper, SP-15
Loosing up bearings and grippers.
MoreBad gripper spring, need a quick fix!
Hello Vanderbloggers! We are in the midst of Open Studios and I planned a few projects to print on my Vandercook 3 (which is sorely underutilized in our shop), and of course, half way through, my grippers have stopped acting normally. The spring that fits in the hole of the gripper cam thingy seems to […]
MoreRegistration on the No. 1
My recently acquired No. 1 proof press (#3639) is an older version sans grippers. The previous owner fashioned a hinged tympan on the bed which I believe was used for registration. He had taped on makeready with gauge pins to the underside of this tympan at one point. However, the press has not been used […]
MoreUniversal II- Cylinder won’t lock at feedboard.
My Universal II has all of a sudden stopped locking when it returns to the feedboard. Therefore when I press the trip pedal nothing happens (grippers don’t move) and it makes a sharp ‘bang’ noise releasing the tension of the pedal… Thoughts? Trip spring? Please help. Thanks, Adrian
More