On my Vandercook Universal 1 the printing pressure at the bottom of the sheet releases (sometimes but not always) at 4 inches from the end of a 22 inch sheet causing the printing to be lighter. There seems to be no consistency in its happening. Sometimes the printing is fine and sometimes its light starting […]
Morehelp sp15
Sp15 been in storage many years for move and building etc. Bearing blocks for form rollers lost. Also trip for paper release was broken.
MoreExcuse the mess
This site is is undergoing a system upgrade and reorganization. Please use search field if you cannot find what your looking for, or contact me and I will do my best to direct you to the information you need. The dust will settle shortly. Thank you for your patience. Pjm
MoreSP-25 Ink Drum
Having recently brought to the shop a nearly untouched SP-25, and in the midst of attempting to sort out the electrical nightmare (550V-3-phase), I’ve run into a problem I’m hoping folks around here might be able to help me with. The press was originally bought in the mid-60s, and it sat in a warehouse as […]
MoreSP-15 belt issue
During our Open House yesterday, the belt on our older SP-15 slipped off the motor pulley. After the gig, we opened up the top and put the belt back on, but it looks like it may easily slip off again. This press has geared wheels at the motor and the drum roller, and the rubber […]
MoreDid RotaDyne REQUIRE you to fill out a W9 and Credit Application?
We needed rollers on our Vandercook recovered and RotaDyne was kind enough to send a representative to check out the rollers, and take them with him to recover. However, shortly after, I got an email from RotaDyne with a Credit Application and W9 to fill out. Since the business is a sole proprietorship, I didn’t […]
MoreNeed rollers for Challenge 1528 KP
greetings all I am new to the forum, and was hoping someone could help me track down form rollers for a challenge proof press. My rollers were thrown out by a janitor (i had them off of my press so i could do some brayering) and it’s been difficult to track any down. i may […]
MoreVandercook No. 4 Roller MR-110 Pin Replacement
I was wondering if someone knew where I can find a MR-110 Pin for the #4? Thanks!
MoreRestoring a Vandercook 03 [updated]
Hello everyone! I’ve undertaken the task of restoring my 03. I’ve started with paint thinner to degrease the bearings system where the previous owner had it all greased up, and thus it gather a severe amount of gunk. I disassembled the carriage and down to the impression cylinder. I’ve gotten most of the grime off. […]
MoreVandercook Cocktail Competition
Call for Entries: The Vandercook Cocktail To honor the Vandercook Proof Press, it’s history and significance, and it’s place in our lives, a competition has been created for the design of the specialty cocktail to carry its name. “The Vandercook Cocktail” will be chosen from recipe submissions gathered throughout the letterpress community. Testing/tasting will take […]
More[WANTED] Vandercook SP15
I’m looking for a Vandercook SP15 over the world, i prefer with motor one, no parts missing. Please contact me any time if you have one and ready to sell it. Thanks! calvinvtc@gmail.com
MoreSP-15 Motor Update
On November 11, we installed the newly rewound motor into the SP-15. It is not as noisy as it was, but still noisier than our other press. Questions: 1. is there any way to dampen the noise? I was tempted to put some insulation in the chamber, but don’t want to cut down on heat […]
More