Enrique asked me if he could use a No.4 oscillator on his SP15. The answer is yes. The tubes are the same diameter (3¾”) and the worm gear is the same part (DR-338), but the shaft and tube length of the SP15 is longer (13″) than the No. 4 (12½”). While the No. 4 […]
MoreCategory: *Model
SP-15 Oscillator
Hi everyone, I am still looking for an oscillator for my SP-15. Does anyone have one lying around gathering dust? or know of some one who does? Please contact me if you do. Thanks a lot.
MoreRoller bearing blocks position, nyliners and spring
Hi everyone, Looking at photos of other sp-15s I noticed that my press came with the spring pulling on a different piece than it should. Is this (2nd photo) the right arrangement? My press is the first photo. Also, my bearing blocks are obviously wrong, I will change them tomorrow. I also want to know […]
MoreNew SP-15 issue
We were able to kinda-sorta fix the SP 15 belt slipping by installing a new belt. Now there is a new issue: there is a knocking or clunking sound when all the rollers are in contact (the down position). We checked for things like a loose gear on the back form roller; it is ok. […]
MoreLockup bar for sp-15
Hi, I am looking for a lockup bar for SP-15, serial 26228. Does anyone have a spare one? Any suggestions? Thanks, widok
MoreInconsistant inking on sheet
On my Vandercook Universal 1 the printing pressure at the bottom of the sheet releases (sometimes but not always) at 4 inches from the end of a 22 inch sheet causing the printing to be lighter. There seems to be no consistency in its happening. Sometimes the printing is fine and sometimes its light starting […]
Morehelp sp15
Sp15 been in storage many years for move and building etc. Bearing blocks for form rollers lost. Also trip for paper release was broken.
MoreSP-25 Ink Drum
Having recently brought to the shop a nearly untouched SP-25, and in the midst of attempting to sort out the electrical nightmare (550V-3-phase), I’ve run into a problem I’m hoping folks around here might be able to help me with. The press was originally bought in the mid-60s, and it sat in a warehouse as […]
MoreSP-15 belt issue
During our Open House yesterday, the belt on our older SP-15 slipped off the motor pulley. After the gig, we opened up the top and put the belt back on, but it looks like it may easily slip off again. This press has geared wheels at the motor and the drum roller, and the rubber […]
MoreVandercook No. 4 Roller MR-110 Pin Replacement
I was wondering if someone knew where I can find a MR-110 Pin for the #4? Thanks!
MoreRestoring a Vandercook 03 [updated]
Hello everyone! I’ve undertaken the task of restoring my 03. I’ve started with paint thinner to degrease the bearings system where the previous owner had it all greased up, and thus it gather a severe amount of gunk. I disassembled the carriage and down to the impression cylinder. I’ve gotten most of the grime off. […]
More[WANTED] Vandercook SP15
I’m looking for a Vandercook SP15 over the world, i prefer with motor one, no parts missing. Please contact me any time if you have one and ready to sell it. Thanks! calvinvtc@gmail.com
More