Hello! I have a question pertaining to the hardware on a number 01 vandercook proofing press. Provided are images of said hardware. I will call them “stoppers” as that is what they do-they prevent the roller from rolling off the press bed. Recently a colleague caused the roller to get stuck partially off the press […]
MoreCategory: *Model
Uni 1 Form Roller Gear Spinning Out
Our Uni 1’s back form roller gear is spinning out on the starting teeth of the rack. I’ve changed the roller height, made sure the end screws on the roller core are tight, made sure the spring beneath the starting teeth is free of debris (it depresses with finger pressure). I’ve had this issue on […]
More#4 Broken Body?
IMG_853IMG_8534 The body of my #4 is damaged. The corner opposite the operator at the far end of the press bed is not supported. You can see that the bottom of the frame is not level as well. Bringing the carriage to the end of the press causes it to rock back and forth. I […]
MoreVandercook 4 Cylinder Dry Sound. How to oil or fix?
Sad Sounding Cylinder Not sure how to check or maintain the bottom cylinder with a dry, desperate sound that needs help soon. Any help would be appreciated! – Lacy
MoreSP 15
Hello everyone. I bought a Vandercook SP 15, I have no experience in the subject and I would like to know the basic steps to start cleaning and remove rust from the rollers. The machine was not used in the last 10 years and may be missing some small pieces although the car moves and […]
MoreHandle Removal / Gear Puller?
Hello, Back again. Posted in November about a pin removal on my Universal I handle. In the end we had to drill out the top half and then were able to tap it out. Now we need to get the handle off. Is a gear puller our best option? Thank you, Alison
MoreVandercook 215 gripper pedal chain slack
Hello, We have a Vandercook 215 in our shop that has been going through maintenance and now we have arrived on the gripper pedal chain slack. We have started to notice the dead pedal with about three links worth of slack in the chain and the pedal is about 1-2 inches off the ground before […]
MoreVandy No. 3 parts removal
Does anyone have suggestions on how to remove the carriage roller and cylinder trip rack frames that are attached to the cylinder carriage support wall via three bolts and three set pins/studs? The bolts are the easy part. Or should these not be removed? See sheet 99 for views. Thanks.
More#4 Form Roller frame- how much play?
I’m working (virtually) on a #4 that previously was working great, and all of a sudden there are roller issues. The pins and clutch plate were replaced in January so they don’t seem to be the issue. What seems to be happening is that the entire frame moves side to side with the motion of […]
More320 Gripper Bar Sheet Guide Studs—Bent?
I’m (still) refurbishing a Vandercook 320, and I’ve started attacking the gripper bar. I have it all apart and clean enough to handle, but I have noticed that the studs that hold and adjust the sheet guides seem to be a little off-square. It looks somewhat like the result of crashing the guides (several times), […]
MoreSP25 carriage gear adjustment
I have a problem with the large power carriage motor gear touching the edge of the carriage. Not sure I’m using the correct terminology but I have attached a photo. I had this problem once before and was able to correct it but now I can’t remember what I did. (I took off the cap […]
MoreReturn tapes buckling trailing edge of sheet
We have a Uni 1 PAB with the automatic tape sheet delivery tower. When using the return tapes, particularly with short sheets, the sheets get buckled on the trailing edge and can hang up or get mangled by the form. The pdf Uni 1 manual states: Caution When using the Automatic Tape Sheet Delivery, the […]
More