Hi everyone. First post here. I am looking for at least one SP-15 roller core. If anyone has any to spare that would like to sell, please let me know. Thank you very much in advance.
MoreMore TagCategory: Form rollers
Vandercook 320G issues
I’m in the thick of trying to get my Vandercook 320G up and running. This is different than other Vandercooks I’ve printed on for various reasons (it’s completely manual, the metal and rubber rollers are behind the cylinder, etc). I’ve encountered a couple of things so far that I’d love advice with if you have […]
MoreMore TagIs there an SP-15 specific full moon?
We have a new (to us) SP-15, no manual, sadly. The front rubber roller adjustment knobs very suddenly stopped moving. At all. If it were one side or the other, that would be one thing, but they are both immobile, and they had been turning fine earlier in the day. I removed the roller, and […]
MoreMore TagRollers
I’m getting the rollers for my Universal I recovered and noticed when I was making a case for them, that one roller has got straight edges, the other slightly tapered edges. Is there any particular reason?
MoreMore TagRollers Universal I
The rollers on my recently acquired press are in a bad state and I will have to get them re-covered. Any indication as to what kind of hardness of rubber I will have to ask for? Soft, hard, medium? Any advice is welcome.
MoreMore TagVandy 3 – Inking Roller Question
Our inking roller on our Vandy 3 is a bit worn, so we’re wondering if we should get it replaced before we print an initial run. We tried it out before purchasing the press, just to test it out, and it seemed to distribute the ink pretty well since it is still quite soft. That […]
MoreMore TagSP-20 roller bearer
I seem to be having an issue with one of the bearers (is that even the right term?) on the rear form roller on my SP-20. I can’t lower the roller height to type-high on that side. I can on the user side, but not on the opposite end. No problem with the front roller. […]
MoreMore TagSP20 Form Roller Screws
I’m attempting to remove the hardware from my SP20 roller cores to ship them off to be recast. I’ve removed the tiny set screw from inside the larger, outer, screw on the end of the roller, but now I can’t seem to remove the larger, outer screw. I don’t want to turn it too hard […]
MoreMore TagSP15 “bearer controlled form roller support system” + nylon wipers
I’m hoping to clarify a few SP15 related mysteries. Apologies in advance for the multiple reference photos….
MoreMore TagRecasting Rollers
Hello All, In a few days we’ll be sending out the cores for our SP15 and SP20 form rollers to be recast. Would it be a good idea to have them recast at a slightly larger diameter (perhaps 2.51 inches for the SP15 and 3.01 inches for the SP20) to make them last a little […]
MoreMore TagRollers stop spinning
Hello, we have an SP-15 used by college students in a typography studio. A problem occurs with the rollers when you move the carriage over the the bed. To start the rollers ink up fine and evenly, but as you begin to turn the carriage handle all of the rollers suddenly stop spinning. They seem to […]
MoreMore TagChallenge 20 KP Rollers
Hello, I just picked up a Challenge 20 KP and the 3 rubber rollers are shot. I would greatly appreciate any info such as size and durometer so I can replace them. Thanks, Coby
MoreMore Tag