Hi there, Does anyone know how to temporarily stop the oscillation of the oscillating roller on an SP-15? I have a project I’m hoping I can do a blending technique with, and I was thinking it would go much easier if there’s an easy way to stop the oscillation of that top roller. The area […]
MoreCategory: SP series
SP-15 ink drum gear broken
Hi there — This is my first post. I have an SP-15 (serial #26151), and I looked through my manual, but am still unsure of the part names. It appears the gear on my motorized roller is broken. This is the gear that the belt / pulley (?) runs on to actually move the roller. […]
MoreSp-15 lock-up bar not locking to the side
I’m unfamiliar with exactly how a lock-up bar works but I don’t think mine is not working correctly. The extension block will not move when I tighten the bar down. (isn’t it suppose to?) I’ve taken it apart and noticed that there was a spring like part inside but when I put my finger in […]
MoreSp-15 form roller help!!
A friend and I just had our rollers recovered from NA Graphics and we’re sitting here putting them back together and the gear will not line up where it is suppose to. It’s the same for both sets of rollers. We’ve tried each side and every roller trying to get the gear to line up. […]
MoreSP15 in Sacramento
I was wasting time and noticed this in California. Notify your friends or get yourself another press. How about number ?? Daniel? [ Link invalid ] Chris
MoreSP15 hand gripper lever
Last week I was in New York to teach workshops at the “Center for Book Arts”:http://centerforbookarts.org/, and also visited a couple of printshops including Daniel Morris’s “The Arm Letterpress”:http://www.thearmnyc.com/information/letterpress in Brooklyn. Some readers may know that has several Vandercooks including this rather unusual SP15 that has a hand lever mechanism to raise the paper grippers […]
MoreSP-15 ink roller and gear…
Could someone either take a nice close-up digital photo or carefully measure (wrap a piece of paper around it and measure) the circumference of both the form roller (the one that actually touches the type) and the gear that drives it as it moves across the press? The outside diameter of my gear is noticeably […]
MoreSp-15 trip spring reference
Thanks to Paul’s recent post regarding trip spring replacement, I was able to discern that my SP-15’s trip/print problem is that both springs are broken. I spoke with Fritz today for advice and ordered new ones. I know there was a photo recently posted by John Cristopher showing a carriage off the press with the […]
MoreSP20 Trip Spring Repaired
I recently repaired an SP20 at the University of West Georgia on which the carriage had become stuck during the return travel. The photos above shows that top carriage bearings on the operator’s side had been removed during a previous repair attempt. Typically what happens on SP series presses is that the trip spring inside […]
Moresp-15 another part identification required
can anyone tell me what other parts would be required to make the sheet finger operate – view the parts i have on “flickr”:http://www.flickr.com/photos/8286330@N03/ thanks again! john christopher arcane devices
MoreSP-15 for sale in Brooklyn
Noticed this on the Briar Press website – is this being sold by anyone on here? [ Link invalid ] best john christopher
Morebroken spring on an SP-15
hi all I’m calling on the fount of collective knowledge here with a technical question. I’m refurbishing an sp-15, and as I was cleaning up the underside of the cylinder carriage I noticed that a rocking lever arm (what is I assume part of the trip mechanism) was sprung with a flat spring on one […]
More