Somehow the wooden ink drum bearing on the operator side of my Universal III managed to work itself loose and ended up inside the drum, leaving the drum loose on that end of the shaft. I managed to remove the wood composition bearing from another spare ink drum I had and pressed it onto the […]
MoreCategory: Universal series
Universal III (hand) carriage question
Greetings! I have recently made a purchase of a Universal III press and am currently ironing out shipping. The sole wrinkle in getting this press into my studio is that the carriage is too wide for a few interior doors (this is a old home) by three inches. My two options are to keep said […]
MoreUniversal III Power carriage drive motor/gearbox
Hello I’m the new owner of a Universal III P which arrived less the carriage drive motor/gearbox/clutch assembly. I have a very good machinist/electrician who has suggested he could adapt a small variable speed motor gearbox combination to fit. Trouble is he has no idea about motor hp, gear ratios, whether the motor would have […]
MoreVandercook manual
Good morning, I am binder in France and last week I bought this vandercook press. I do not find informations on this model so I therefore need of your help a lot. Thank you
Morelooking for a universal 1 in san francisco (not to buy)
hello! i am visiting san francisco this week, and want to take a gander at a universal 1. i have one in mexico, and it has several very strange quirks that i can’t seem to get figured out. i’m hoping that seeing one in good condition (and meeting with a fellow printer) will help illuminate […]
MoreUniversal I – Replacement Motor
In response to the recent post regarding an SP- 15 needing a replacement motor, I thought I’d add my experience this week with our Universal I. This press had been hesitating at start-up for some time. On start-up, the drive roller would need a little nudge to get it going. (I believe the capacitor was […]
MoreUniversal III automatic / control relay switches
We are having some trouble with our Vandercook Universal III Automatic. We THINK it is in the relays. It will sometimes not start moving when it should. Switching the forward / reverse back and forth will sometimes help. It helps to set the press speed faster which is what makes us believe the problem is […]
MoreAsbern vs Vandercook
Hello I’m a graphic designer in Spain. I’m planning on setting a press here. I’ve been offered an Asbern AD1 and a Vandercook Universal I. The Asbern is cheaper but I don’t really know if the Vandercook is much better, if it’s really worth paying more. As you can see, I have no experience in […]
MoreUni I up for auction in Ohio on December 6
Don’t know if everyone’s seen this. Looks nice! http://www.wiredbids.com/auctions/december-printing-bindery-packaging-equipment-auction/lots/vandercook-universal-i-power-pro Barbara
MoreVandercook Uni I motor repair (internal gear issue – photos included)
Hello All, I recently brought my Uni I motor to be recoiled / rebuilt. It started to smoke and eventually burnt out. The motor had previously been working and turning the cylinder (a bit slower than normal, but functioning). I received a call from my machinist, who after taking it apart told me the internal […]
MoreQuestion about Frisket Frame for Uni-I
Folks, I noticed that the Universal Parts manual shows a “Frisket Frame” unit for a Uni-I. Is this frisket only for the motorized Uni or would it also work on a manual (hand-cranked) Uni-I ? Thanks. /thomas/
MoreUniversal III Power Carriage, Braking Problem
I’ve read up on all the relevant old post I could find, and I still have a few questions about this. I’ve adjusted the clutch, and it’s still hitting at both ends on the lowest speed. Not very hard (yet), but enough to bounce of an inch or two. Sometimes the breaking dial helps, sometimes […]
More