Manuals

Fabricating Replacement SP-15 Impression Cylinder

I’m considering grabbing an SP-15 press but, like many presses out there, getting it into running order will require some TLC. The press bed, cylinder rack, bed bearers, under rails, gripper pedal, trip latch & rail along the bed, steel cabinet, and feed table all check out and seem to need nothing more than heavy …

Fabricating Replacement SP-15 Impression Cylinder Read More »

I am looking for info on my Potter Press

I’ve had a Potter #2 for about 10 years. I’ve happily been doing small runs of woodcuts and engravings with it. Still I’d like to make it work like it once did. I’ve got some beat up grippers, but that’s the extent of it. I’m looking for information as to how these presses went together. I have questions, and possibly …

I am looking for info on my Potter Press Read More »

Challenge 15MPC

I am reconditioning a 15MPC and am in need of an MPC manual or a pic of the impression Cylinder drive. I believe the parts are all there to reconnect except for the friction wheels (guessing) that ride the main drive shaft. Any help here would be greatly appreciated. Regards Steve