I’ve been running a Vandercook 425 for a little under a year and am finding that I would really like to get the ink fountain working. However, I think I’m missing a part. The 425 Manual that I have (thank you Paul!) shows an ink fountain system that looks very different from mine, so I […]
MoreKnurl Pin Sheered Off
After cleaning up my new Universal III I was still having trouble getting the grippers to open at the end of the bed. After hunting around this blog, I discovered a post that indicates that the knurl pin is the problem. You had posted a very helpful diagram! (below) Anyway, the top is broken […]
MoreVandercook SP15, lowering gear side of rear form roller
The gear side of the rear roller on our SP15 will not lower enough to hit a roller-setting gauge. It does have a range of motion, just will not descend low enough to contact the gauge on the gear side. The roller measures about 1/8″ less than 2 1/2″ in diameter. The tip diameter of […]
MoreUniversal I stopping when in print, but not in trip
Hi All, I just pulled an old Universal I out from the corner to see what issues there may be. When in Trip the carriage rolls all the way down the bed fine. When I put it in Print, the Press stops when the cam follower hits the trip wedge. There is a bit of […]
MoreVandercook 4, pulley set screw won’t stay tight
The top wheel of the motor assembly pulley on my Vandercook 4 (#12545) keeps loosening. The set screw tightens, but loosens after the motor runs for a bit. The wheel and the belt move on the post toward the operator, away from the motor. This is a recurring problem, but every once in a while […]
MoreUni III Blowing Fuses
Working on some electrical gremlins on a Uni III that is blowing its 5amp fuses (larger ones). When in manual mode, the carriage will go to the end of the bed with no problem but will not return and it appears to blow the fuses once at the end of the bed. Should I be […]
MoreShudder In Vandy 215 (aka 4) Oscillator
Lately my Vandy 215 oscillator has a shudder as it travels back and forth. It actually seems to be stocking to the inked up rubber rollers below. I was able to stop the chatter by adding a small piece of lead between the metal roller assembly and the bearing block of the rubber rollers (see […]
MoreSP 20 Trip Assembly misaligned on one side
Hi all, I’m the new caretaker of an SP 20 (serial 23442). I’ve been investigating a carriage jam issue and have found that the trip assembly on the non-operator side of the carriage (X-21755) is sitting much lower than on the operator side. Because of this, the rogue trip arm has been scraping against the […]
MoreChain Problem on Universal III
I just acquired a nice Universal III which I’ve been cleaning up. I started up the motor today and after about a minute, it stopped, although it was still humming. I shut everything down and pulled off various covers and have isolated the problem to the chain. It’s stuck in the gear that sits BELOW […]
MoreUni III roller bearer issue?
Looks like when new rollers were put on the press, two of the roller height adjustment mechanisms were put on backward, so that the locking nut faces the wrong way. I assume they should face inward, but we have two that face outward. Anyway, a few days ago, one of the rings came off the […]
MoreUniversal I PAB | Control Station Panel Replacement
Howdy. I trust you and yours are well. I recently did some electrical work (thank you Fritz, Daniel, Paul, Steve, John, and Max) on my Universal and I am replacing the Control Station panel. Would anyone like one while I am at it? This will be a laser-engraved, silver substrate revealing a black core to […]
MoreBlack #4
Came across a nice #4 but it is black Do you know if Vandercook made black ones? Norman Hicks +1 415-725-1670
More