Hi everyone, Looking at photos of other sp-15s I noticed that my press came with the spring pulling on a different piece than it should. Is this (2nd photo) the right arrangement? My press is the first photo. Also, my bearing blocks are obviously wrong, I will change them tomorrow. I also want to know […]
MoreNew SP-15 issue
We were able to kinda-sorta fix the SP 15 belt slipping by installing a new belt. Now there is a new issue: there is a knocking or clunking sound when all the rollers are in contact (the down position). We checked for things like a loose gear on the back form roller; it is ok. […]
MoreLockup bar for sp-15
Hi, I am looking for a lockup bar for SP-15, serial 26228. Does anyone have a spare one? Any suggestions? Thanks, widok
MoreRoller ID Help
Anyone know what kind of roller this is for? http://katranpress.com/roller.jpg Some sort of older Vandercook. The face of the roller measures 14.875 inches wide. The cores are 20 inches wide. Many thanks.
MoreInconsistant inking on sheet
On my Vandercook Universal 1 the printing pressure at the bottom of the sheet releases (sometimes but not always) at 4 inches from the end of a 22 inch sheet causing the printing to be lighter. There seems to be no consistency in its happening. Sometimes the printing is fine and sometimes its light starting […]
Morehelp sp15
Sp15 been in storage many years for move and building etc. Bearing blocks for form rollers lost. Also trip for paper release was broken.
MoreExcuse the mess
This site is is undergoing a system upgrade and reorganization. Please use search field if you cannot find what your looking for, or contact me and I will do my best to direct you to the information you need. The dust will settle shortly. Thank you for your patience. Pjm
MoreSP-25 Ink Drum
Having recently brought to the shop a nearly untouched SP-25, and in the midst of attempting to sort out the electrical nightmare (550V-3-phase), I’ve run into a problem I’m hoping folks around here might be able to help me with. The press was originally bought in the mid-60s, and it sat in a warehouse as […]
MoreSP-15 belt issue
During our Open House yesterday, the belt on our older SP-15 slipped off the motor pulley. After the gig, we opened up the top and put the belt back on, but it looks like it may easily slip off again. This press has geared wheels at the motor and the drum roller, and the rubber […]
MoreDid RotaDyne REQUIRE you to fill out a W9 and Credit Application?
We needed rollers on our Vandercook recovered and RotaDyne was kind enough to send a representative to check out the rollers, and take them with him to recover. However, shortly after, I got an email from RotaDyne with a Credit Application and W9 to fill out. Since the business is a sole proprietorship, I didn’t […]
MoreNeed rollers for Challenge 1528 KP
greetings all I am new to the forum, and was hoping someone could help me track down form rollers for a challenge proof press. My rollers were thrown out by a janitor (i had them off of my press so i could do some brayering) and it’s been difficult to track any down. i may […]
MoreVandercook No. 4 Roller MR-110 Pin Replacement
I was wondering if someone knew where I can find a MR-110 Pin for the #4? Thanks!
More